- Admin
- #21
Yes, and yes.Did you run a factory reset and reload your settings??
Yes, and yes.Did you run a factory reset and reload your settings??
Yes, and yes.
Yup, checked, double checked. Its off.Make sure that your config file doesn't have R2 on.
You dont turn sensors on or off. If a previous sensor configuration was memoried with a sensor on the R2 port and a sensor is no longer connected it will send an error. If you dont have a R2 sensor run a reset defaults to memorize the current configuration.Yup, checked, double checked. Its off.
I have reset mine now, more than once, R1/R2 are both turned off in my config, haven't been activated since 2014.You dont turn sensors on or off. If a previous sensor configuration was memoried with a sensor on the R2 port and a sensor is no longer connected it will send an error. If you dont have a R2 sensor run a reset defaults to memorize the current configuration.
Sent from my SM-N960U using Tapatalk
Again you are misunderstanding the error. Pull a stats report and look at the actual and memorized configuration.I have reset mine now, more than once, R1/R2 are both turned off in my config, haven't been activated since 2014.
Pull a stats file and email it to me.There is NOTHING connected to the port, there hasn't been in years.
I’ve also noticed the ALP randomly losing GPS signal for a few seconds since updating. I’m in a urban area and my GPS module is mounted right on my front windshield so that’s not the issue. All was fine prior to the update as well.
What version firmware does your control set have?Can you PM me an email address...
My control set hasn't worked properly in a while but all still works fine via bluetooth, so will have to be a screen shot from stats via the app.
I'll send it a bit later tonight, I have to get the kid to gymnastics shortly.
Try it out, I only had the GPS issue for a day. Seems like it went away on its own.So...guidance is to hold off or what?
Stats says 6.9What version firmware does your control set have?
I installed this update yesterday, and I always restore defaults + memorize sensors, then create a new config file on the website just to be safe / prevent any possible bugs.
Zero issues with this update on my end. (I'm using HiFi, no bluetooth or anything).
If you want to be tested say so, I don't live that far from you.Think I got this one. Can't comment. Driven 1000km since it dropped and haven't been shot once. (shrugs)