Search results

  1. D

    R3 NZ 1.46 new map update??

    Cheers,
  2. D

    R3 NZ 1.46 new map update??

    Has anyone got a new map update for there R3 in NZ, i have the old one from @DEMON5. I also cannot delete old locations for fixed speed cameras off using the "hold mute button" at all. Anyone having any luck with this? Thanks
  3. D

    R3 NZ V1.46 with NZ database

    Thanks for the reply, I also got help from Demon for the 1.37 upgrade. I just wanted to make sure that it was fine to use it again and that the nz database didnt need to updated etc for 1.46.
  4. D

    R3 NZ V1.46 with NZ database

    Has anyone updated their R3 to 1.46? if so did you just reload the nz database from the link on the forum?
  5. D

    R3 NZ a lot of Laser alerts??? FW1.37

    Thanks for the feedback, will try disabling Iris scanner as a start.
  6. D

    R3 NZ a lot of Laser alerts??? FW1.37

    Is anyone else getting a lot of laser alerts on their R3, I have just updated it to 1.37 and changed to a different car photo attached for placement. So i dont know if its might be the firmware or the placement in proximity to my cell phone (S8). I have seen another thread where they suspected...
  7. D

    Updated NZ-model R3 to 1.31

    Hi Mate are you still in contact with DEMON5? i have updated it to 1.37 now but just getting no response from DEMON5. So now i essentially now have a R1 with GPS lockouts lol. On the positive note 1.37 is good.
  8. D

    How do you private message someone on here?

    Is it just starting a conversation with them on their profile?
  9. D

    Updated NZ-model R3 to 1.31

    Thanks,
  10. D

    Updated NZ-model R3 to 1.31

    Quick question, is it best to send a message on the profile page, or start a new conversation with a person?
  11. D

    Hi Demon5, would you be able to help me out with the NZ database for the r3?? Thanks

    Hi Demon5, would you be able to help me out with the NZ database for the r3?? Thanks
  12. D

    Updated NZ-model R3 to 1.31

    Thanks for the reply, will do.
  13. D

    Can you update the Uniden R3 NZ update to 1.37 without affecting the nz camera database??????

    Hi, Does anyone know if this will be ok to do, or has already done it. Thanks,
  14. D

    Updated NZ-model R3 to 1.31

    Have you guys updated to the latest, 1.37? is the nz database still unaffected?
  15. D

    RJ11 extension cable - Uniden R3

    Hi, I just got a R3 and was wanting to know if you get a RJ11/12 connector and extension cable to run around the pillar. Will the mute button still work on the plug base? Thanks,
Top