This is hands down the best way to mount your detector to your vehicle. I’ve usually used the windshield suction cups and kept it up towards the center of the headliner but this thing is clean and almost makes it part of the vehicle.
Can believe I waited this long to get this thing!
Got it. Thanks!
Also, is there any reason to run X Band on any longer? I believe I used to keep it off when I had my Saavy and BT dongle.
If it doesn't hurt/interfere or make something less effective then I'll just keep it on.
Thanks guys. I reset my V1 back to factory defaults. I had to as it has been a while since I messed with these settings. So starting over is best.
Here's what I did. Tell me what you think. This is just a plain old V1 without any Savvy or BT module...straight radar detector.
1. X Band: On...
Ha, that’s what I’m thinking and still quite possible. Although if you saw how my install was on my Audi S5 and all of the components I removed, it’s hard to think I would have done this.
I had the concealed display along with a separate very small mute button for quick access on the dash...
I’ve had a V1 since the late 90’s. I’ve sent them in for upgrade throughout the years but in 2014 I quit using as I didn’t need a radar detector in my company van because I live 1 mile away from my new shop location.
Anyways it’s been sitting in a box ever since. I broke it out the other week...
Long time V1’s user and have had one since 1998ish. I’ve always sent it in for an update whether it was just software or both over the many years.
I haven’t used my V1 in about 4 years as I didn’t have a need for it. After reading this thread I’m guessing I should wait as it says mine has an...
I have my 650S mounted to the right of my rear view mirror on my compnay van and have the power wire coming out to the left. It seems to be recording upside down. Is there a way to flip the way it's recording?
Nice install on your S5. Here's something I did that you may want to try. I added my external speaker for my LI up in the dash where the center speaker is located. I purchased a spare B&O speaker (I think it was 3") ran my wire leads from the LI module up to that area which is actually pretty...
Re: Does the latest release fix the double voice prompt saying, "Parking Aid Activate
Good to hear. I probably just needed to reload the firmware and voice packs, I just haven't had time. I'll give it a shot this weekend.
and "Welcome" right after one another.
It only does this right after the vehicle is started from being off and you switch to the parking sensor mode. It works fine if you don't switch on the parking sensor mode and it just says "Welcome" like normal.
I've read NOTHING but numerous comments after comments about how much better YaV1 is than the stock V1 application that comes with the V1C from Valentine One. Is there going to be a iOS version in the works?
Excited to try it out.
No, the alerts are at various locations.
I have the Audi Side Assist, but if you turn off POP it doesn't set the V1 off. Though I'm not sure whether POP in on/off since I'm running the V1 Connect with custom sweeps...I thought custom sweeps or turning on Euro Mode it removed POP but not sure...
I'm having trouble connecting these three components. I'm running the V1C (iPhone), Concealed Display, and a Mute Button. I bought a 3-way splitter from Radio Shack (link attached).
The splitter has labeling as follows:
The only time I can get my V1C connected is...